Dynamips: How to save vlans after switch reload

By On November 11, 2008 · 3 Comments

Most of you already know that in Dynamips after a reload of a switch all the vlans and vtp configurations are gone. There is a way how to save the vlan and vtp configuration even in case of a reload of the switch and I will show you below how to do it. For switch emulator I used a Cisco 3640 IOS image with a NM-16ESW module to have Layer 2 port on the device.

Click below to see the movie and explanation:

How to save vlans after switch reload

How to save vlans after switch reload

Tagged with: • • • •
 
If you enjoyed this article, please consider sharing it!
Reddit FacebookTwitterDelicious
  • Juan Gordillo

    So helpful. I need it very badly.
    Thanks,

    juan carlos

  • http://www.firstdigest.com Calin

    Hi Juan,

    I’m glad that it was helpful!

    Cheers,
    Calin

  • Xao

    Excellent tutorial! Just great!